2
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
WorkUp
®
Adjustable Table - Model HF
Assembly Instructions
Tabletop Support-to-Columns
Assembly
1. With the assistance of a second
person, hold both foot/column
assemblies in the upright position,
orienting the two column cables
inward as illustrated (Figure 2).
2. Position the tabletop support onto
the foot/column assemblies and
allign the four holes in one end of
the support with the four holes in the
column (Figure 2).
3. Attach the tabletop support to the
column using four M8 x 18 mm
screws until snug, then tighten each
screw one quarter turn at a time in a
diagonal pattern until all four screws
are tight (Figure 2 & Detail A).
4. Attach the second foot/column in the
same manner (Figure 2).
Base-to-Tabletop Assembly
Note:
Except for the “P” shaped
cable clamps, the tabletop is
pre-drilled for installation of all
components.
1. To avoid scratching the tabletop,
place it with the top side down on a
soft, protective surface (Figure 3).
2. Place the tabletop support with
columns on the drilled face of the
tabletop so the heads of the M8 bolts
set into the pockets milled in the
tabletop. The support should now be
flush with the tabletop (Figure 3).
3. Move the tabletop support with
columns slightly to align the holes in
the tabletop with those in the support
(Figure 3).
4. Attach the tabletop using
#12 x 1” tapping screws in each
available hole (Figure 3).
Figure 3
tabletop
#12 x 1”
screw
tabletop
support
assembly
Figure 2
tabletop
support
column
cables
foot/column
assembly
M8 x 18 mm
screw
Detail A
