Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Repair & Replacement Instructions
Uniframe
®
Tables
Latch Removal & Installation
February 2018
Required Tools
• Hammer
•
5
/
32
Pin Punch
Latch Removal & Installation
1. Open the table half-way to gain
access to the broken table latch
(Figure 1).
2. Move under the table and locate the
broken table latch (Figure 2).
3. Where the latch rod goes through
the slot plug, remove the rubber cap
from the latch rod handle using your
finger tips (Figure 3).
4. From inside the apron, use a hammer
to gently tap the slot plug free from
the apron and save for re-installation
on page 6, step 11 (Figure 4).
5. Using a
5
/
32
” pin punch and hammer,
tap out the
5
/
32
” roll pin from the 2
1
/
2
”
clevis pin on the outer leg. Once the
roll pin has been removed, slide the
clevis pin out of the table latch and
leg brackets (Figure 5).
Figure 1
Uniframe
table
Figure 3
latch
rod
rubber
cap
slot
plug
table
latch
Figure 5
5
/ pin punch
32
”
hammer
5
/ ” roll pin
32
2 / ”
1
2
clevis pin
Figure 2
table
latch
Figure 4
latch
rod
slot
plug
hammer
apron
