4
Lancaster
®
Auditorium Seating with Power & Data
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Upright
Note:
If any lighted end panel
uprights are to be installed, see
appropriate pages (11 or 14) and
install wiring before installing
upright(s) to the floor.
1. Align the holes in the upright foot
with the floor anchors (Figure 1).
Insert appropriate fasteners with
flat washers through to the floor.
Do not tighten uprights to
the floor at this time
. Leave
fastener loose with head
approximately
1
⁄
16
” from
contacting the foot of the upright
(Figure 1).
Riser Mount
1. When mounting uprights to the
face of a riser, the upright
mounting holes should be 3” off
the floor (Figure 2).
