10
Lancaster
®
Auditorium Seating with Power & Data
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Power & Data Side Cover
Installation
1. Slide the rear flange of the power
& data side cover between the
back upholstery and the back
bracket (Figure 12).
2. Rotate the side cover until the
two square holes snap over
the receptacle and data adapter
installed to the upright
(Figure 12).
3. Place a flat washer and grommet
onto a
1
⁄
4
-20 x
5
⁄
8
”
Torx head
screw as illustrated (Detail B).
Make sure that larger, flat face of
grommet is against the washer.
4. Slide the
1
⁄
4
-20 x
5
⁄
8
”
Torx
head screw with washer and
grommet through the bottom
hole in the side cover, through
the corresponding hole in the
upright, and twist on a
1
⁄
4
-20
acorn nut. Secure screw with
washer and grommet to the acorn
nut (Figure 12).
