Lancaster
®
Auditorium Seating with Power & Data
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
11
End Panel
1. Connect the end panel to the
upright with four screws
provided (see note below). The
top two screws go through the
top upright holes and into the
threaded insert in the end panel.
The bottom two screws must first
be routed though the end panel
bottom bracket, then into the end
panel (Figure 13).
Note:
Plastic end panels use
four
1
⁄
4
-20 x
5
⁄
8
” screws. Wood
and laminate end panels use two
1
⁄
4
-20 x
5
⁄
8
” bottom screws and
two
1
⁄
4
-20 x 1
1
/
4
” top screws.
Aisle Lights
Note:
The LED aisle light wiring
is to be connected to a 12VDC
Class II power supply by a
qualified electrician who must
check the electrical integrity of the
finished system. The steps below
are intended as a guideline for
installation.
Note:
Transformers or power
supplies are not provided.
LED Aisle Light
1. Place the aisle light into the aisle
light housing (Figure 14 &
Detail C).
2. Align LEDs to show through
openings in the aisle light
housing bezel (Figure 14).
3. Route the light’s power wire
through the end panel, through
the top electrical hole provided
in the aisle upright and down the
upright. The power wire must run
through a connector nut, then
through the bottom electrical
routing hole in the upright,
through the 90° metal connector
and through the flexible conduit
to a 12VDC Class II power supply.
Make all connections as required
(Figure 13 & Detail C).
Important:
Observe polarity when wiring.
+ (positive) is the copper wire.
- (negative) is the silver wire.
