63
Angle Adjustable Locking Flip Up Extendable Armrest
1. Set the angle of the armrest. There are five holes that can be used to set the angle. Tighten the bolt
using a 10mm wrench once angle is set.
2. Set the length of the armrest. To adjust the length, remove the bolts and spacer on the tube and the
screw closest to the back of the chair using a 10mm wrench and a Phillips screwdriver. Slide the
armrest to desired length available by the predrilled holes and reinstall the screw and bolts.
3. Set the height of the armrest. There are four holes on the armrest that allow for two different height
settings for each set of holes on the back tube. Use the holes that provide the correct height setting for
the user. The two bolts pass through the spacer, sleeves, back posts and into the armrest using a 4mm
Allen wrench.
1 2
3 4 5
Four bracket holes give two
location options per backrest
hole (Use 1 & 3 or 2 & 4).
1
2
3 4