Ki Mobility Catalyst 5, Инструкция пользователя и гарантия

Страница: 34 / 92

33
IV. WHEELCHAIR USE & CONFIGURATION
T. Anti-Tips (Continued)
How to Turn the Anti-Tip Tubes Up (Fig. 23)
1. Press the rear anti-tip tube release pin (Fig. 23:A).
2. Hold the pin in and turn the anti-tip tube up.
3. Release the pin.
4. Repeat with the second anti-tip tube.
5. Return the anti-tip tubes to the down position after completing the maneuver.
How to Adjust the Position of the Swing Away Anti-Tip Receiver (Fig. 24)
The anti-tip receiver should only need to be adjusted if you make changes to your chair. Minor
height adjustments are made by adjusting the anti-tip tube height. If changes are made that
require adjustment to the position of the receiver, fol low the steps in this section. The holes on
the frame allow for changes in 1" increments.
1. Remove the hardware that connects the anti-tip tube receiver to the side frame of your chair.
2. Place the bracket at the desired height by moving it up or down along the frame.
3. Reinsert the bolts and tighten. If the bolts also connected the armrest and the axle plate, you
may need to contact your supplier for additional hardware.
4. Repeat with the second anti-tip tube receiver. Both the receivers should be at exactly the
same height.
A
Fig. 23
Fig. 24