8
Installation
Levelling the unit
- To do this adjust the 2 leveling feet at front of the unit.
- If the unit is not level, the doors & magnetic seal
alignments will not be covered properly.
9
Installation
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Location
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall
unit must be at least 100mm. Ideally, however, the appliance should not be positioned below overhanging wall
units. Accurate leveling is ensured by one or more adjust-able feet at the base of the cabinet.
Warning! It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
Electrical Connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your
domestic power supply. The appliance must be earthed. the power supply cable plug is provided with a contact
for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth
in compliance with current regulations, consulting a qualified electrician. The manufacturer declines all
responsibility if the above safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
!
Climate class Ambient temperature
SN
+10˚C to +32˚C
N
+16˚C to +32˚C
ST
+16˚C to +38˚C
T
+16˚C to +43˚C
UF225
Unscrew hinge cover
Open the door & unscrew
the top hinge. Then take the
door from the cabinet and
place it on a soft pad to
avoid damage.
Carefully lie down the
rear of cabinet on a soft
pad. Remove two leveling
feet first. Then unscrew
the door hinge and left
foot base.
Remove the cover &
screws at left side &
fit them to right side.
Caution!
If there is a screw at left front corner, remove it before install hinge.
Unscrew & remove the bottom hinge pin, turn
the bracket over & replace it.
Install the hinge at left
side and foot base at
right side. Then screw
two leveling feet with
their original parts.
unscrews
screws
Unscrew top hinge
pin and mounte it to
left hole.
Stand up the unit and put the door on the bottom hinge. Make sure
the bottom hinge core is inserted in the door hole. Then fit upper
hinge with the door. Before tightly fix the upper hinge, try to open the
door to check whether the cabinet is sealed well. Finally, screw the
hinge cover with hinge.
Daily Use
First use - Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm
water and some neutral soap so as to remove the typical smell of a brand new product, then dry throughtly.
Important!
Do not use setergents or abrasive powders, as these will damage the finish.
Temperature setting
- Plug on your appliance. The internal temperature is controlled by a
thermostat. These are 3
MIN, NORMAL
and
MAX
. MIN is warmest setting
and
MAX
is coldest setting.
- The appliance may not operate at the correct temperature if it is in a
particularly hot or if you open the door often.
NORMAL
MAX
MIN
