KHIND EAC20, Инструкция по эксплуатации

Страница: 5 / 28

EN
5
Operation Instructions
Cleaning & Maintenance
A) Installation Method
After taking out the product, firstly remove Water Pump Rod Stopper as shown in Fig. 1, then slide
the Water Pump Slider to the bottom as shown in Fig. 2, so that the pump rod extends down into the
tank and allows normal operation.
B) Function Buttons
Note:
The buzzer beeps twice when the power is first turned on, and the unit enters the standby state
(power on sound: BiBi, button pressing sound: Bi, power off sound: Bi--). All buttons except On/Off
are invalid.
1. On/Off button
In standby mode, all buttons except On/Off are invalid. Press the On/Off to turn on the unit, and
the circuit enters working state. The initial wind speed of the unit is medium by default. The
corresponding normal mode LED turns on, no timing, wind direction and cool / humidify
functions are available.
In power on state, press this button, and the unit will turn off and enter standby mode. Press
this button again, and the unit will resume last wind speed. If the wind speed before shutdown
is low or silent, it starts from the medium level and switches to low or silent level after 3
seconds. If the wind speed before shutdown is medium or high, it enters medium or high level
directly. The natural mode and sleep mode won’t be saved. In this case, the unit enters normal
mode by default, and the swing function, timer and humidify function are saved.
2. Do not clean the appliance with metal scouring pads as it may scratch the surface or cause
electrical shock.
3. Empty the water tank to avoid odour when not using the appliance.
4. If the product won’t be used for long period of time, remove the water tank, drain the water, and
then install the unit properly. Turn on air dry function, fully dry Honeycomb Filter, unplug the
power cord, pack the unit properly to prevent dust, and place in a dry and ventilated place.
Then slide the
Water Pump Slider
to the bottom
Remove Water
Pump Rod
Stopper
(Fig.1) (Fig.2)