Keysight U8903B, Руководство пользователя

Страница: 525 / 605

Appendixes A
Keysight U8903B User’s Guide 525
External frequency sweep
Table A-28 Measurement settings > External Frequency Sweep menu tree description
Tab Level 1 Level 2 Level 3 Description
External Frequency
Sweep
(Signal Generation)
Instrument
– Keysight 33220A
– Keysight 33250A
– Keysight 33500A
– Keysight 33600A
– Other
Select the instrument model.
GPIB Address – 0 to 30 Select the GPIB address.
Init Instrument
– On
– Off
Enable or disable the U8903B to send SCPI
commands to initialize the connected
signal generator.
Init SCPI
– Edit
– Import
Set the SCPI commands that initialize the
connected instrument. You can set the SCPI
command directly or load from a file.
Sweep SCPI
– Edit
– Import
Set the sweep SCPI commands that initialize the
connected instrument. You can set the SCPI
command directly or load from a file.
Sweep Config
Start Set the start value for the sweep parameter.
Stop Set the stop value for the sweep parameter.
Spacing
Select Log, Linear, or Custom for the sweep
spacing.
Points Set the number of sweep points.
Step Size
Set the step size for linear spacing. This setting is
only available when spacing is set to Linear.
Dwell Time Set the delay between the sweep points.
Edit Points
Point No Set the point number.
Point Value Set the point value.
Insert Point Above Insert a point above the selected point.
Insert Point Below Insert a point below the selected point.
Remove Point Remove the selected point.
Clear Clear all points.
Reverse Order Reverse the order of the points.
Sort Sort the points in ascending order.
Load Points
Load points from a file.
Refer to “
Appendix 13: Recall Menu Tree ” on
page 494 for the recall menu tree.
Save Points
Save the points to a file.
Refer to “
Appendix 12: Save Menu Tree ” on
page 493 for the save menu tree.