52
Keysight PD1000A Power Device Measurement System Startup Guide
IV and CV Device Characterization
Running the IV and CV Tests
7
Click the
X
icon to close the Hardware Configuration dialog.
Figure 22
Close the Hardware Configuration dialog to apply settings
Set Initial Test Settings
For detailed information about each test, refer to the PD1000A Control Software
Help File. (Click the help (
?
) icon in the upper right corner of the display.)
1
Demo Mode:
Check this box if you want to run the IV/CV Demonstration. This
provides a simple current/voltage plot and result (*.mdm) file. See “IV and CV
Demo” on page 86.
2
DUT Type:
Choose
FET
or
IGBT
from the drop-down list. (If you are using a
B1505A power device analyzer, you must also select the test type:
IV
,
CV
, or
Gate Diode
.)
3
Set the
Temperature Control Mode,
depending on whether you have the InTEST
Thermal Platform (HP289-PM, available separately, contact
www.inTESTthermal.com
)
– Fully Remote:
If you have the InTEST Thermal Platform, enter the
temperature(s) you want tested in the temperature field, separated by
semicolons (;). The software automatically heats the test chamber and
triggers the measurements when each temperature is reached.
Figure 23
Select Initial Test Settings
Содержание PD1000A
