38
N2795/6A User’s Guide
4
Performance Verification
Test 2. Bandwidth
This test ensures that the Probe meets its specified bandwidth.
N2795A bandwidth:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 GHz
N2796A bandwidth:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 GHz
NOTE
Allow the probe to warm up for at least 20 minutes.
Using the 8720ES VNA successfully
Remember these simple guidelines when working with the 8720ES
VNA during this procedure.
• Sometimes it may take a few seconds for the waveforms to
settle completely. Allow time for waveforms to settle before
continuing.
• Make sure all connections are tight and secure. If needed, use a
vise to hold the cables and test board stable while making
measurements.
• Be careful not to cross thread or force any connectors. This
could be a very costly error to correct.
Procedure
Initial Setup
1
Turn on the 8720ES VNA and let warm up for 20 minutes.
2
Press the green
[Preset]
key on the 8720ES VNA.
3
On the VNA, press the
[Power]
key and set the power to 0 dBm.
4
On the VNA, press the
[AVG]
key and then select the
Averaging
Factor
screen key. Set averaging to 4.
5
On the VNA, press the
[Sweep Setup]
key and then press the
sweep type menu
screen key. Select the
log freq
screen key.
6
Connect the probe under test to the Auto Probe Adapter and
power the probe using the 1143A power supply. Install the
outside thread adapter to the Auto Probe Adapter.
Содержание N2795/6A
