Keysight M9502A, Руководство пользователя

Страница: 23 / 142

Keysight M9502A/M9505A AXIe Chassis User Guide 13
Power-Up and Power-Down Introduction
To Power Up the Chassis
Plug-In Chassis
Using the supplied cord, connect the chassis to an
appropriate AC power main.
Close Circuit Breaker
Close the rear panel circuit breaker
Press On/Standby Button
Press the chassis’
ON/STANDBY
switch. It should
light when depressed
The STATUS light on the ESM will cycle as follows:
1
Light off - with button in STANDBY mode
2
Amber, steady - after pressing switch, ESM is performing a power-on self-test
(POST)
3
Green, blinking - for a few seconds after POST
4
Green, steady - successful chassis power-up is complete
1
2
4
The chassis and host PC must be powered up and down in the following
sequence. The chassis should be powered up first, which will initiate its built-in
self test. During self test, the chassis STATUS LED will be amber. The STATUS
LED will blink green and then stay green continuously when the ESM is ready.
The ESM then powers up each module slot. The remote host PC should be
turned on only after all installed modules have performed their
initialization—see your module documentation for initialization information. An
embedded controller such as the M9536A handles this sequence automatically.