32
Keysight M8100A Series Arbitrary Waveform Generators Getting Started Guide
2
Basic Setup for M8100A
Step 6 - Connect M8008A Clock Source to M8199A AWG Module
Following are the possible ways to connect a M8008A clock source to the
M8199A AWG module(s):
Case 1
Connecting M8008A clock module to M8199A AWG module
In this case, make the connections as described below:
1 Connect the 45 cm 1.85 mm blue clock cable (M8199-61624) from
Sample Clk Out of M8008A to Clk In of M8199A.
2 Connect the M8199A-811 sync cable (M8199-61620) from Sync Out of
M8008A to Sync In of M8199A.
on page -32 shows how to connect the M8008A clock generator
module to the M8199A AWG module:
Figure 11
Connecting M8008A clock generator to M8199A AWG module
M8008A
M8199A
NOTE
The unused output should be turned off or terminated with 50 Ohms.
