Keysight M5200A, Руководство для стартапов

Страница: 51 / 80

M5200A PXIe Digitizer Modules Startup Guide 51
Setting up the M5200x software 3
c Ensure that Python has been added to the ‘PATH’ in ‘System
Variables’. If it does not appear, you must manually add an entry.
Figure 19 Verifying addition of Python to PATH environment variable
6 On the command prompt window shown in Figure 18 , you may
optionally enter the following commands to install the ‘NumPy’, ‘SciPy’
and ‘Matplotlib’ libraries:
• python -m pip install numpy
• python -m pip install scipy
• python -m pip install matplotlib
After each library is installed, you should see a message “ Successfully
installed... ”. If you encounter any error, exit the command prompt
window and launch a new one to repeat steps 5b and 6.
The procedure for downloading and installing the M5200x software,
Module firmware, PathWave FPGA Board Support Package and KS2201A
PathWave Test Sync Executive software are described further in this
chapter.