Keysight Ixia IxOS, Руководство по началу работы

Страница: 16 / 110

Rack Mounting Precautions
If the chassis is installed in a Rack Mount, observe the following precautions:
a. Elevated Operating Ambient Temperature: If installed in a closed or multi-unit rack assembly, the
operating ambient temperature of the rack environment may be greater than room ambient
temperature. Therefore, consider installing the equipment in an environment that is compatible
with the maximum allowable ambient temperature specified for the chassis (40° C).
b. Reduced Air Flow: Install the equipment in a rack so that the amount of air flow required for safe
operation of the equipment is not reduced.
Do not block the back or sides of the chassis, and leave approximately two inches of space
around the unit for proper ventilation.
c. Mechanical Loading: Mount the equipment in the rack so that a hazardous condition is not caused
due to uneven mechanical loading.
d. Circuit Overloading: Consider the connection of the equipment to the supply circuit and the effect
that overloading of the circuits might have on current protection and supply wiring. Pay attention
to equipment nameplate ratings when addressing this concern.
e. Reliable Earthing: Maintain reliable earthing (grounding) of rack-mounted equipment. Pay special
attention to supply connections other than direct connections to the branch circuit (such as use of
power strips).
Use End Caps on Open Ports
The metal edges of the SFP and SFP+ ports are SHARP. To avoid injury, ALWAYS keep unused SFP
ports covered with end caps. When installing a load module into a chassis or removing from a chassis,
ensure that the end caps are in place on unused ports.
To prevent accidental injury to personnel, do not leave unused SFP (or SFP+) ports uncovered. When
transceivers are not installed, end caps must be used.
Chapter 2 Installation
– 5 –