U3020AS16
Performance Verification
1-
Measurement Setup
1.
A
s shown
the two RF cable
s
using a 3.5 mm
female to
female adapter.
2.
Normalize the displayed response trace on the PNA.
3.
Remove the 3.5 mm adapter from the setup.
4.
Connect the PNA Port 1 cable to Test Set
Reflection Port
.
5.
Connect the PNA Port 2 cable to Test Set Port 1.
6.
Establish control of the Test Set with the controller via the LAN
connection.
7.
Execute the sequence command <ROUT:SEQ:TRIG
r
p1 > to create
a
Reflection Port to
Port 1 signal path.
is representation of the S21
response trace. Markers shown are not provided in the procedure above.
for typical Insertion Loss values.
8.
While observing the front panel
, the LED above Port 1 should be green "R."
9.
Execute each of the available switch path selections from the SCIP
command listing and observe that the correct Status LED display is
ON,
and that the S21 path response is similar to that provided in
.
Figure
6
Typical
Insertion Loss
Plot
20
Keysight U3020AS16 User's and Service Guide
