Keysight Technologies U1818A, Руководство по эксплуатации и обслуживанию

Страница: 8 / 47

8 Keysight U1818A/B Operating and Service Manual
Figure 2-20 The recommended way to coil and store your probe . 27
Figure 2-21 Steps to mount the browser in the ergonomic handle 28
Figure 2-22 Steps to remove the browser from the ergonomic handle
29
Figure 2-23 Attaching the SMA head support . . . . . . . . . . . . . . . . 30
Figure 2-24 Correct securing methods . . . . . . . . . . . . . . . . . . . . . . 31
Figure 2-25 Incorrect securing method because glue is placed on the
probe head tip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
Figure 2-26 Holding tip with vise . . . . . . . . . . . . . . . . . . . . . . . . . . 34
Figure 2-27 Use trim gauge to gauge the wire . . . . . . . . . . . . . . . . 36
Figure 2-28 Cut the wires even with the trim gauge . . . . . . . . . . . 37
Figure 2-29 N5382A wire bend down at about 30 degree . . . . . . . 37
Figure 2-30 ZIF tip (open position) and ZIF probe head . . . . . . . . . 39
Figure 2-31 ZIF tip (closed position) with ZIF probe head inserted 39
Figure 2-32 IC package for example ZIF tip installation . . . . . . . . . 41
Figure 2-33 Solder added to target points . . . . . . . . . . . . . . . . . . . 42
Figure 2-34 Fluxing of the target points . . . . . . . . . . . . . . . . . . . . . 42
Figure 2-35 Small amount of solder added to ZIF Tip of soldering iron
43
Figure 2-36 ZIF tip positioned and soldered in place . . . . . . . . . . . 44
Figure 2-37 Using non-conductive tool to open the ZIF connector . .
45
Figure 2-38 ZIF Tip left behind in DUT with ZIF latch open . . . . . . 45
Figure 2-39 Use non-conductive tool to close the latch . . . . . . . . 46