Keysight Technologies 85058V, Руководство пользователя и сервисное руководство

Страница: 33 / 58

85058V 3-13
Use, Maintenance, and Care of the Devices
Connections
Connections
Good connections require a skilled operator. The most common cause of measurement error is
bad connections. The following procedures illustrate how to make good connections.
How to Make a Connection
Preliminary Connection
1. Ground yourself and all devices. Wear a grounded wrist strap and work on a grounded,
conductive table mat. Refer to “Electrostatic Discharge” on page 3-2 for ESD precautions.
2. Visually inspect the connectors. Refer to “Visual Inspection” on page 3-3 .
3. If necessary, clean the connectors. Refer to “Cleaning Connectors” on page 3-6 .
4. Use a connector gage to verify that all center conductors are within the pin depth values
listed in Table 2-2 on page 2-4 . Refer to “Gaging Connectors” on page 3-8 .
5. Carefully align the connectors. The male connector center pin must slip concentrically into
the contact finger of the female connector.
6. Push the connectors straight together and tighten the connector nut finger tight.
CAUTION Do not turn the device body. Turn only the connector nut. Damage to the center
conductor can occur if the device body is rotated.
Do not twist or screw the connectors together. As the center conductors mate, there is
usually a slight resistance.
7. The preliminary connection is tight enough when the mating plane surfaces make uniform,
light contact. Do not overtighten this connection.
A connection in which the outer conductors make gentle contact at all points on both mating
surfaces is sufficient. Very light finger pressure is enough to accomplish this.
8. Make sure the connectors are properly supported. Relieve any side pressure on the
connection from long or heavy devices or cables.
Final Connection Using a Torque Wrench
Use a torque wrench to make a final connection. Table 3-1 provides information about the
torque wrench recommended for use with the verification kit. A torque wrench is not included in
the verification kit. Refer to Table 6-3 on page 6-7 for part number and ordering information.
Using a torque wrench guarantees that the connection is not too tight, preventing possible
Table 3-1 Torque Wrench Information
Connector Type Torque Setting Torque Tolerance
1.85 mm 90 N-cm (8 in-lb)  9.0 N-cm (  0.8 in-lb)