12
Simple Troubleshooting
■
Situation 1
Situation 2
Situation 3
Situation 4
After the installation of the lockset and batteries, the door cannot
be locked and three short beeps are emitted when you press the
Programming button.
After the installation of the lockset and batteries, no responses
when you press any button (no sounds are emitted, and the back
light does not work).
Fail in the first execution of the door-handing indentifying process
(the red light flashes three times, and three short beeps are emitted).
Although succeeded in the first execution of the door-handing
indentifying process, the latch does not work.
(Feeling that the motor runs powerlessly, the latch bolt is stuck,
and the turn-piece inside cannot be rotated.)
Causes
Solutions
Causes
Solutions
Causes
Solutions
Causes
Solutions
: The door-handing indentifying process is not yet complete.
: Please execute the door-handing indentifying process as soon as the
installation of the lockset is completed.
: It could be a problem caused by the batteries or the improper connection of
the cable.
: Check to see if the battery polarities have been reversed or if the battery is
dead. If so, please re-install or change the battery. If not, please check if
the cable is appropriately connected.
: Wrong door-handing or change of the door-handing in the memory.
: Press the R button to restore the system to factory default setting and
re-execute door-handing indentifying process.
: Low battery.
: Please replace with new batteries.
11
Programming Code (PC)
USER Code (UC)
Enter PC
6
Set Autolock Time Delay
Enter Seconds
(10~99)
Remark : 10-99 seconds delay-time available.
Toggle Mute On/Off
Enter PC
7
Remark : Repeat same steps to turn beeper On/Off.
LED illumination is still functioning when it's in mute.
But there will be no any warning alarm.
Enable/Disable All User Code
Enter PC
8
Create a disposable User Code
Enter PC
9
Enter new
disposable
UC
Remark : Auto-locking and Keypad locking function will be invalid when User Codes
are disabled. The lock can only be operated by key during the time.
Repeat the steps to enable the User Codes again.
Restore all preset lock settings
Press
R
Remark : Press “R” button for over 5 seconds, the programming will complete after
you hear 3 long beeps.
After restore, you need to run the door handing identifying process before
other function setting.
Remark : Disposable code will be no longer valid once being used.
