1
KEYPAD ELECTRONIC DEADBOLT
INSTALLATION INSTRUCTIONS
2-3/4"
(70mm)
The BACKSET is the distance between the center of
cross bore and edge bore of the door.
Adjustable latch fits both BACKSET of 2-3/8” (60mm)
and 2-3/4” (70mm). Please follow the steps shown
below for BACKSET adjustment.
Latch Backset Adjustment :
.
Rotate the latch case as diagram on the
right for backset 2-3/4" (70mm) or
reverse direction for 2-3/8" (60mm)
1. Mark The Door With Template
Select the height and backset as desired on the
door face ; use the TEMPLATE as an indication
to mark the cente of the circle on the door face
and the center of the door edge.
r
2. Drill Holes
Using the marks as a guide to drill a hole Ø2-1/8”
(54mm) through the door face for the lockset, then
a hole of Ø1” (25.4mm) for latch.
2
a. Insert the latch and ensure it is paralleled to
the door face.
Mark the outline of the faceplate, then take
out the latch.
b. Chisel 1/8” (3mm) deep along the outline to
allow the faceplate to be aligned with the door
edge.
c. Insert the latch and tighten it with screws.
Note : please use tapping screws for metal
door.
b. Chisel 5/64” (2mm) deep along the strike
outline to allow the strike to be aligned with
the doorframe.
c. Insert the strike and tighten it with screws.
Note : please use ”tapping screws” for metal
door.
4. Install Strike
3. Install Latch
a. To identify the center of strike :
close the door, on the basis of the faceplate
mark horizontal cente line of strike.
Ensure the cente of faceplate and the cente
of strike are aligned.
Use the mark as a guide outlines the strike
r
r
r
.
