iButton Series Programming Guide
Section: Programming Guide Non-Software
E4 Lock
The reset button is located just below the battery holder in a recessed hole. Use a narrow object
such as a straightened paper clip to press the button in. Press and hold the reset button below the
battery holder. The LED in the center of the iButton reader will light green. After 5 seconds the
lock will beep once. Continue to hold the button down until the LED flashes red slowly. Release
the reset button immediately and press the # key while the LED is still flashing. The lock will beep
3 times, indicating the reset and clear has been successful.
Lock Manufacturer Default Settings, E4 / E5:
These settings apply for a new lock or one that has had a full reset as per the reset procedures above:
•
Default master code: 123456
•
Auto unlock/lock: Disabled
•
Default lock mode: Storehouse mode
•
Default Daylight savings mode: Disabled
•
Construction code: 0#, only applies until first regular user code is programmed.
Keyless Enty Locks
For current prices, please visit our website.
www.KeylessEntyLocks.com
46 Danada Sq West #4133
Phone: (630) 909-9504
Wheaton, IL 60189
Page 7 of 58
FAX: (630) 447-3635
LockO
Path: Z:\KEY\suppliers\Lockey\website-KEL-zc\_dev\pdfs Modified 08/1
2
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com
©KeylessEntryLocks.com