KEY RK-2006LSPz, Руководство по эксплуатации

Страница: 13 / 36

13
4.6. Flame optical detection parameters.
These parameters specify operation of burner flame optical detector. If the system
is fitted with flame temperature detector, parameters change and viewing is
unavailable.
The current furnace brightness determined by an optical detector - this
parameter displays the current flame brightness measured by the optical detector.
C U R R E N T F U R N A C E
B R I G H T N E S S 2 8
Brightness when fuel ignition has occurred - if the optical detector reading will be
equal or higher than this desired setting, the controller will switch off the igniter and
assume that ignition has occurred.
I G N I T I O N O F F A T
B R I G H T N E S S 1 4
4.7. Flame detection temperature parameters.
These parameters specify operation of the temperature detector of burner fuel
ignition. If the system is fitted with optical fire burner detector, parameters change
and viewing is unavailable.
Burner measured temperature - this parameter displays the current measured
burner temperature.
M E A S U R E D B U R N E R
T E M P E R A T U R E 6 6 c
Burner temperature with fuel ignited - if ignition temperature is equal or higher
than this desired setting, the controller will switch off the lighter and assume that
ignition was provided.
I G N I T I O N O F F A T
T E M P E R A T U R E 2 0 0 c
4.8. Information on burner work.
Parameters described below refer to counters that accumulate information on
operation of the burner since its first start. It is not possible to cancel counter
readings.
Burner work time.
Reading of this counter defines burner work time. The counter updating follows
after total working hour of the device at maximum or minimum power.
B U R N E R W O R K
T I M E 1 3 h