KD-CDA6 Operating Instructions
Page 6
KD-CDA6 Operating Instructions
Page
5. I have a picture but there is noise or “hum bars” visible in the image.
This could happen when crossing power lines when routing the cable from the “Source”
device to the KD-CDA6, or when routing the cables from the KD-CDA6 to the “Display”
device. If crossing power lines is inevitable, make sure to use heavy shielded high quality
cable. Sometimes using a shielded and noise filtering surge protector can eliminate noise
in power lines.
6. I have No Audio.
When connecting the Left and Right (White and Red connector) stereo audio channel
make sure that the connectors are properly connected to the “Source” device as well as
the “Display” device.
Make sure that the volume is turned up to an audible level on the “Source” device as well
as the “Display” device.
When using the Digital Audio connection “PCM” or coaxial audio, make sure that the
“Display” device is capable of decoding this compressed bit stream of audio information.
Most often when using the “PCM” audio function, the audio will be connected to a Dolby
Digital
®
capable AV-Receiver or amplifier.
Key Features for KD-CDA6
Enables signal distribution any HDTV or SDTV Component Video source to Component Video
HDTV ready monitors
Component Video Left and Right Analog Audio; Digital PCM audio can be used instead of the
Left and Right Analog Audio Signals
RCA connectors for all video and audio inputs and outputs
300 MHz bandwidth
Drives video signals up to 300 feet
Can be cascaded to another KD-CDA6 to drive as many outputs as desired from one source
External power supply
Crystal clear image
Metal Enclosure
Cost-effective
2 years parts and labor warranty
a.
a.
b.
c.
›
›
›
›
›
›
›
›
›
›
›
Technical Specifications
Model #: KD-CDA6
— 6 Channel Component/RGBHV Video/Audio Distribution Amplifier
Each input and output is comprised of five RCA connectors consisting of independent HDTV/SDTV
Component Video (YPrPb) plus two channels of audio L&R or PCM digital audio.
Video:
Standard YPrPb 1 volt p-p 75 Ohm terminated Component Video.
Video bandwidth:
- 3 dB @ 300 MHz.
Audio:
Standard “line” type high impedance two-channel, Left & Right. Each L or R can be used for
PCM digital audio.
Cable Recommendation
Each run of YPrPb cable MUST be the same length (300’ max.).
KD-CDA6 Characteristics:
Size: 4” x 8” x 1-13/16”.
Weight: 1.5 lbs. (.7 Kg.)
Orientation/Mounting Information:
The top and bottom of the unit are solid metal (no vents).
The unit may be oriented horizontally, or mounted vertically on a wall. Use 2 #8 or M4 screws to
hang the unit (keyhole slots are provided on the base of the unit). If installing into sheet-rock or
hollow walls, provide proper screw support with bolts or sheet-rock anchors.
Limited Warranty: 2 years parts and labor.
›
›
›
›
›
›
›
›
›
Key Digital
®
Exclusive Technologies
Key Digital
®
Exclusive Technologies
KD-CDA6_Manual.indd 6-7
9/7/06 4:49:07 PM
