7
4.4.1 - RELAY 1 AND 2 CONFIGURATION PROCEDURE
4.4.2 - TIMERS SETTING
5 - TESTING AND COMMISSIONING
The system may be put into operation after testing by a qualified technician, who must
perform the tests required by the relevant standards in relation to the risks present, to
check that the installation complies with the relevant regulatory requirements.
on the associated remote control, once released it opens. ATTENTION: any disturbances can open
the contact even if the remote control button is still pressed.
•
Timer seconds:
in this mode it is possible to set a time in seconds after which the relay contact
opens. By default, the timer has a setting of 30 seconds. ATTENTION: the timer is reloaded every time
an associated transmitter is pressed.
•
Timer minutes:
in this mode it is possible to set a time in minutes after which the relay contact opens.
By default, the timer has a setting of 30 minutes. ATTENTION: the timer is reloaded every time an
associated transmitter is pressed.
FLASHES
MODE
1 Flash
BISTABLE
2 Flashes
IMPULSIVE
3 Flashes
SECONDS TIMER
4 Flashes
MINUTES TIMER
PH. DESCRIPTION
EXAMPLE
1
Press the
S
button of receiver. The LED R1 relating to relay
1 starts flashing, to switch to relay 2 press the
S
button,
then the LED R2 starts flashing. The LED (R1 or R2) of the
selected relay flashes according to the set mode:
S
►
R1
PH. DESCRIPTION
EXAMPLE
2
Press the
P
button to change the desired operating mode.
Each time the
P
button is pressed again, the configuration
passes to the next mode in a cyclic manner.
P
►
+
R1
3
Exit the configuration by repeatedly pressing the S button
until the LEDs go off.
S
PH. DESCRIPTION
EXAMPLE
1
While in timer mode (seconds or minutes) hold down the
S
button for about 2 seconds and wait that the LED (R1 or R2)
to flash regularly (one flash per second).
S
►
+
R1
2
Hold down the
S
button and count the number of flashes of the
LED you want to set as seconds or minutes. Example: count
5 LED flashes to set 5 seconds/minutes depending on the
previously selected mode.
S
►
+
R1
3
Once you have counted the flashes you want to set, release
the S button.
