6
4.1 - MEMORISING A REMOTE CONTROL
4.2 - DELETING A REMOTE CONTROL
4.4 - RELAYS CONFIGURATION
4.3 - CLEARING THE RECEIVER MEMORY/RECEIVER RESET
WARNING: When the memorisation phase is activated, any transmitter within the reception range
may be memorised. To reduce the receiver’s range, disconnect the antenna temporarily.
PH. DESCRIPTION
EXAMPLE
1
Press the
P
button of the receiver to select relay 1
P
2
The
R1
LED starts flashing. To switch to relay 2 press the
P
button again, the
R2
LED starts flashing.
R1
3
After selecting the desired relay, press the button of the
remote control you want to record and keep it pressed until
the
R1
,
R2
and
RX
LEDs remain on steady a few seconds
may pass before the receiver decodes the new code.
2s
Note Repeat the operation for all the codes you want to enter in
the receiver.
PH. DESCRIPTION
EXAMPLE
1
Press the
P
button of the receiver, the
R1
LED starts flashing
P
►
R1
2
Press the
S
button of the receiver
S
3
The
R1
,
R2
and
RX
LEDs light up steadily
R1
+
R2
+
RX
4
Press and hold down the button of the remote control button
that you want to delete until all the LEDs turn off. The remote
control has been successfully deleted
Note Repeat the operation for all the codes you want to delete
PH. DESCRIPTION
EXAMPLE
1
Press and hold the
P
and
S
buttons for about 10 seconds
P +
S
> 10 sec
2
Wait until the
R1
,
R2
and
RX
LEDs flash quickly, then
release the buttons
R1
+
R2
+
RX
The relays are configurable in four different modes:
•
Bistable:
the state of the relay is maintained until another pressure of the associated remote control.
When the button of the remote control is pressed, the relay contact closes, the next time it is pressed, it
opens. ATTENTION: the absence of power supply returns the output to its rest state, i.e. open contact.
•
Impulsive (factory setting):
the relay contact remains closed for the entire duration of the pressure
