Key Automation REVO, Инструкции и предупреждения по установке и использованию

Страница: 10 / 52

10
EN
Code Description
REV2024 24 Vdc gear motor for hinged doors with max length 2,3 m or weight 250 Kg, 230 Vac
REV2024S 24 Vdc gear motor for hinged doors with max length 2,3 m or weight 250 Kg, without control unit
REV20110 24 Vdc gear motor for hinged doors with max length 2,3 m or weight 250 Kg, 110 Vac
REV2224M 24 Vdc gear motor for hinged doors with max length 2,3 m or weight 250 Kg, 230 Vac
REV2224S 24 Vdc gear motor for hinged doors with max length 2,3 m or weight 250 Kg, 230 Vac
TECHNICAL DATA
MODELS REV2024 REV2024S REV20110 REV2224M REV2224S
TECHNICAL SPECIFICATIONS
Torque
Nm 120 120 120 120 120
Working cycle % 80 80 80 80 80
Opening time at 90° sec 14-20 14-20 14-20 14-20 14-20
Control board 14A - 14A CT20224 -
Power supply Vac 230 - 110 230 -
Power supply Vdc - 24 24 - 24
Absorption A 0,6 2 1 0,6 2
Engine power W 115 50 110 115 50
Integrated lights yes yes yes - -
Degree of protection IP 44 44 44 44 44
Dimensions (L - P - H) mm 120 - 250 - 350 120 - 250 - 350 120 - 250 - 350 120 - 250 - 350 120 - 250 - 350
Weight Kg 10,5 8 10,5 10,5 8
Operating temperature °C -20°+55° -20°+55° -20°+55° -20°+55° -20°+55°
Leaves maximum weight Kg 250 250 250 250 250
2 - PRODUCT OVERVIEW
2.1 - Description of the product
The RÉVO gear motors are destined to be installed in systems for
the automation of gates with hinged doors.
The RÉVO gear motors have been designed and constructed to be
fitted onto hinged doors within the weight limits indicated in the
technical specifications table.
The use of gear motors for applications which differ from those
indicated above is prohibited.
2.2 - Model and technical characteristics
3 - PRELIMINARY CHECKS
Before installing this product, verify and check the following steps:
- Check that the gate or door are suitable for automation
- The weight and size of the gate or door must be within the maxi -
mum permissible operating limits specified in Fig. 2
- Check the presence and strength of the security mechanical stops
of the gate or door
- Check that the mounting area of the product is not subject to flood -
ing
- Conditions of high acidity or salinity or proximity to heat sources
could cause malfunction of the product
- Extreme weather conditions (for example the presence of snow,
ice, high temperature range, high temperatures) may increase the
friction and therefore the force required for the handling and initial
starting point may be higher than under normal conditions.
- Check that the manual operation of gate or door is smooth and
friction-free and there is no risk of derailment of the same
- Check that the gate or door are in equilibrium and stationary if left
in any position
- Check that the power line to supply the product is equipped with
proper grounding safety and protected by a magnetothermal and
differential security device
- Provide the power system with a disconnecting device with a gap
of contacts enabling full disconnection under the conditions dictated
by the overvoltage category III.
- Ensure that all materials used for the installation comply with cur -
rent regulations