23
EN
4
Installation of the WIRELESS module and management of REMOTE CONTROL
To manage remote controls, the electronic circuit board must have a wireless module. The electronic circuit board can handle several types of code, the
fi rst remote control learned determines the type and, as a result, it is not possible to learn remote controls with codes that differ from that of the fi rst
remote control learned. The codes that can be handled are the 12 to 64 bit standards and, for rolling HCS© type codes, only the fi xed part but not the
rolling counter control. The fi rst transmitter learned determines the type of code that the receiver can handle; consequently the subsequent transmitters
learned must have the same type of code.
4.1 Installation of the WIRELESS MODULE
This operation deletes all codes present in the memory. There is no arrangement for deleting single codes.
The memory must be reset before learning the fIrst remote control so that there are no previously learned codes and no unused codes in the system.
The memory, and thus all the codes, can be deleted when the automation is closed.
1
Make sure that the
DIP5
in
OFF
position.
Keep pressed the button until the led start flashing. 8 seconds.
2
After 15 seconds, release push-button
P
on the circuit board.
Wait until the led start flashing in the normally way.
4.3
Remote control LEARNING
The memorization is possible when the gate is closet. Make sure that the
DIP5
in
OFF
position.
- To memorize the next remote control, repeat the operation from the first passage.
- If the led
INFO
start flashing faster, then slowly and will be turned it means that the coda has been memorized.
- If the led
INFO
is turned on, the remote control is not compatible.
- If the led
INFO
flashes slowly it means that the memory code is full.
4.2
DELETING
the codes memory
WARNING: Never install the module if the electronic circuit
board is powered.
WARNING: The module must be inserted in the correct direc
-
tion
WARNING: If the module is removed after codes have been
learned, the code memory must be reset.
(See DELETING the MEMORY)
Elect. components
at the interior side
Connector on the circuit
1
The automation is in the
CLOSED
position
2
Press push-button
P
on the circuit board. The
led INFO
will turn on.
3
Press and slowly release the wireless control key you wish to associate with the
START
command.
The led INFO flashes and then remains on steady. (START Code learned!)
If you don’t need to associate any START control, wait until the led starts flashing.
4
Press the button of the remote control which should be associated to the
PEDESTRIAN.
If the led flash faster, slowly and then normally it means that the code has been learnt.
If the led is lit on the remote control is not compatible.If the led flash slowly it means that the memory is full.
8 seconds
Содержание CT-400
Страница 27: ...27 Note ...
Страница 28: ...Instruction version 580ISCT 400 REV 03 ...
