Keurig K-CUP K140, Руководство оператора

Страница: 13 / 16

13
SECTION 4
Troubleshooting
SITUATION
Brewer does not
have power
Brewer will not
brew when used
for the first time
Brewer will
not brew
SOLUTION
•
Make sure the power is switched on at the socket.
•
Check to be sure that it is plugged in securely.
•
Try plugging the brewer into a different mains socket.
•
Reset your circuit breaker, if necessary.
•
Make sure the brewer has been turned on and the
green POWER Light is on.
•
The brewer must be primed for the first brew (refer
to page 6).
•
BREW/DRAIN Selector Knob must be set to BREW.
•
If brewer is cold/frozen, wait for two hours for it to
reach room temperature before powering on.
•
The BREW/DRAIN Selector Knob must be set
to BREW.
•
After placing the K-Cup
®
pod in the K-Cup
®
Pod
Holder, make sure that the Handle is all the way
down and the blue BREW Button is flashing.
•
If the blue ADD WATER Light comes on, add water
to Water Reservoir. Fill with bottled or filtered water.
Make sure the Water Reservoir is seated properly in
its base.
•
If the blue ADD WATER Light continues to be
on even after refilling, contact your Keurig
Authorised Distributor.
SITUATION
Brewer shuts off
automatically
Blue ADD
WATER Light, red
HEATING Light
and Brew Size
Indicator Lights
are all flashing
simultaneously
Brewing a
partial cup
SOLUTION
•
The AUTO OFF Energy Save Light will turn on after
30 minutes of non-use. This means that the
brewer is in energy save mode. To enable for your
next brew, press the POWER Button.
•
Completely remove the Water Reservoir and
thoroughly clean (refer to page 10). Make sure the
Water Reservoir is filled with bottled or filtered
water. Return it to the brewer and make sure
it is seated properly, then press the flashing
BREW Button.
•
If you have completed the above procedure two
times and the situation persists, contact your
Keurig Authorised Distributor.
•
The exit needle may be clogged (refer to page 10).
•
Clean K-Cup
®
Pod Holder if necessary and rinse
under a tap (refer to page 10).
•
The Water Reservoir may have been removed
during brewing. Replace the Water Reservoir and
perform a cleansing brew without a K-Cup
®
pod.
•
If the amber DESCALE Light comes on, descale
the brewer (refer to page 11).
•
If you have repeated the descale procedure
on your brewer two times and it is still only
brewing a partial cup, contact your Keurig
Authorised Distributor.