Keurig K-CUP K140, Руководство оператора

Страница: 12 / 16

12
Draining the Brewer
The internal hot water tank of the K140 can be completely drained.
We recommend that the brewer be drained if it is to be transported or
stored for an extended period.
1. The brewer must be powered on and ready to brew.
2.
Remove and empty the Water Reservoir and then replace it to the
brewer. The ADD WATER Light will be come on.
3.
Turn the BREW/DRAIN Selector Knob at the back of the brewer to
DRAIN. The green DRAIN Light will come on.
4.
Press and hold the DRAIN BREWER Button. Water will flow into
the Water Reservoir. CAUTION: The water may be very hot!
NOTE: The process to drain a hot water tank from idle state takes
about a minute.
5.
When the water stops flowing, release the DRAIN BREWER
Button. The internal hot water tank is now empty.
6.
Empty the Water Reservoir and replace back on brewer.
7. Turn the DRAIN/BREW Selector Knob back to BREW and power
off the brewer.
If you need assistance, please contact your Keurig Authorised Distributor.
Storage
Empty the Water Reservoir and drain the brewer before storing
and take care to ensure that you store your brewer in a safe and
frost free environment. We recommend you store your brewer in its
upright position
.
SECTION 3
Service
Beyond these recommended cleaning and maintenance procedures,
this brewer is not user serviceable. For service, please refer to the
Warranty section of this guide.
Cleaning & Maintenance
NOTE: The cleaning action of Keurig
®
Descaling Solution may result in a
foam dispensed from the brewer. This is natural, as the solution is
reacting with the scale inside. For a brewer that is heavily scaled, the
brewer may not fill properly after the descaler is added. If this occurs, you
may see only a small or no output dispensed followed by the sound of air
blowing out. If this occurs:
• Turn off and unplug the brewer.
• If there is Keurig
®
Descaling Solution in the Water Reservoir, discard the
contents, rinse the Water Reservoir thoroughly and refill with water.
• Plug the brewer back in, power on, and repeat the Step 3 Fresh Water
Rinse cycle. The brewer should begin to function normally as the solution
is rinsed out and the scale is removed. If problem persists, allow brewer to
sit unplugged for at least 30 minutes before continuing with the rinse.
For futher descale information please contact your Keurig Authorised
Distributor.