6
Intended use
As a light mirror with dimmable lighting for use in wet
rooms such as bathrooms and toilets.
The product is suitable only for mounting indoors!
Caution!
Only install in frost-free rooms.
Declaration of conformity!
This product complies with
the requirements of the valid EU Guidelines. The dec-
laration of conformity for this product can be requested
from the following address:
KEUCO GmbH & Co. KG, Oesestraße 36,
D-58675 Hemer.
Technical data
– Power supply:
220-240V AC 50/60Hz
– max. Power consumption:
Prod. no.:
Width
Weight
Light
33296 XX1500:
500 mm
9.1 kg
26 W
33296 XX2000:
650 mm
11.0 kg
29 W
33296 XX2500:
800 mm
12.8 kg
31 W
33296 XX3000: 1000 mm
15.3 kg
38 W
33296 XX3500: 1200 mm
17.7 kg
43 W
– Protection rating:
IP20
– Ambient conditions
Temperature:
5°– 40° C
– Light colour
3000 Kelvin
Mounting dimensions
, see page 2 and 3.
Installation
, see
fi
gure 2 onwards on page 18.
Connection,
refer to
fi
gure 3 on page 18.
L
N
EURZQ
EOXH
JUHHQ\HOORZ
Operation
The device can be operated in two modes, refer to
fi
gure 3 on page 18.
Operating mode I
(factory setting)
:
Lighting On/O
ff
at the device button (O
ff
automatically
after power returns).
Operating mode II:
Lighting On/O
ff
at the external light switch (O
ff
automatically after power returns).
Switching the operating mode, see table under
Operation
:
Operation
Button Function
Light on/o
ff
• Pressing the button switches the mirror on with the
selected settings. The white LED goes o
ff
.
• Pressing the button again switches the mirror o
ff
.
The white LED lights up.
To change operating mode
• Switch o
ff
the re
fl
ector.
• Press the button and hold it down for 15 seconds.
- The light comes on again when the operating
mode has been switched.
Repeat the procedure described to re-enable operat-
ing mode I.
• The white LED can be deactivated.
– Switch on the mirror.
– Press and hold the button for 10 seconds.
- The lighting goes o
ff
.
- A short light impulse indicates that the white
LED was deactivated.
To switch the white LED back on, repeat the de-
scribed procedure.
Front and wall lighting
• The front and wall lighting is switched on by press-
ing the button when mirror is switched on.
• Pressing the button again switches the light o
ff
.
Washbasin lighting
• The washbasin lighting is switched on by pressing
the button when mirror is switched on.
• Pressing the button again switches the light o
ff
.
When both lightings are switched o
ff
, the mirror also
switches o
ff
.
Dimming the front, wall and washbasin lighting
• Press the button when the mirror is switched on
and hold until the desired brightness or the end
value has been reached.
The setting is stored and reproduced when switched
on again (only for operating mode I.
Replacement parts with order numbers
, see pages
22 and 23.
The light sources may only be replaced by the
manufacturer, its customer service or by an equally
quali
fi
ed person.
For information about warranty and maintenance, see
the enclosed
Maintenance and Warranty Passport
.
Disposal information!
Equipment with this labelling
must
not
be disposed of in household refuse, but must
be disposed of at a collection centre intended for this
purpose.
EN
Important information, please make sure to read!
