KEUCO IXMO, Инструкция по эксплуатации

Страница: 9 / 44

9
Important information, please make sure to read!
EN
Settings
To get to settings mode, the supply voltage must be interrupted for a minimum of 10 s. After that, restore supply volta-
ge. The LED initially blinks 1x and then lights for approx. 3 s. After that the settings can be changed within the following
3 min.
Mode Activation Con fi rmation
Automatic fl ushing Cover the lower half of the sensor window
with your
fi nger for 10 s until the fi rst
acknowledgement fl ush of water occurs, and
then remove fi nger from sensor window. If the
desired setting level is not achieved, please
repeat the procedure.
The set state is indicated by the blinking of
the LED:
Blinking 1x = 12 hour interval
Blinking 2x = 24 hour interval
Blinking 3x = inactive
Reset to factory
settings Cover the lower half of the sensor window
with your
fi nger for 15 s until the fi rst
acknowledgement fl ush of water occurs, and
then remove fi nger from sensor window. If the
desired setting level is not achieved, please
repeat the procedure.
The LED blinks 5x and con fi rms the reset.
Adjust detection zone Cover the lower half of the sensor window with
your
fi nger for 20-55 s. Take away your fi nger
after the third acknowledgement fl ush of water.
The set state is indicated by the blinking of
the LED:
Blinking 1x = Level 5 (~14 cm)
Blinking 2x = Level 6 (~16 cm)
Blinking 3x = Level 7 (~18 cm)
Blinking 4x = Level 8 (~20 cm)
Adjust run-on time Cover the lower half of the sensor window
with your
fi nger for 25 s. The fourth
acknowledgement fl ush of water indicates that
the mode is active. Remove your fi nger after
the desired run-on time is achieved.
The set time is indicated by the blinking of the
LED:
Blinking 1x = 1 s
:
Blinking 10x = 10 s