Kessel INNO-CLEAN, Руководство по установке, Страница: 118 / 132

118
8. Control of the septic system
8.3.3 Maintenance deadline
Input of the next maintenance deadline by the main-
tenance partner.
8.4.1 Parameters
Change of parameters stored at the factory.
Note: Every change is immediately accepted when
the OK key is pressed. In addition, on quitting this
menu it is possible to save these values in the para-
meter memory (see point 8.4.2) under a separate
name.
8.4.2 Parameter memory
Loading of the values accepted on initialisation and
of the values added under a new name (see 8.4.1).
8.4.3 Date / time
Setting the current date and time.
8.4.4 Floater
Switching the two floaters on and off (second floater
is an optional accessory). The status is displayed in
the system information menu.
8.4.5 Pressure sensor
Activation / deactivation of the pressure sensor. De-
activation deactivates the high water and low water
module and the pressure monitoring system.
8.4.6 High water module
Switching on and off the high water alarm. The height
for the alarm signal preset at the factory is 150 cm.
Parameter
Parameterspeicher
Datum / Uhrzeit
Schwimmer
Drucksensor
Stromüberwachung
HW Modul
UW Modul
Drucküberwachung
Kommunikation
Klassen
Nenngrößen
Sprache
Reset
Informationen
Wartung
Einstellungen
Systeminfo
8.4 Setting menu
8.4.7 Low water module Switching on and off the low water alarm. The height for the alarm signal preset at the
factory is 80 cm.
8.4.8 Pressure monitoring Continuous pressure measurement (monitoring) of the INNO-CLEAN® system. The
preset values should not be changed. The pressure monitoring system is deactivated
by deactivating the pressure sensor (see 8.4.5)
8.4.9 Communication Input / change of the station name, the device number, the modem type, the PINS and
the number of the mobile phone to which possible malfunctions can be sent via SMS
(for a detailed description see separate operating instructions).
8.4.10 Classes Display / change of purification class.
8.4.11 Nominal sizes Display / change of nominal size.
8.4.12 Language Display / change of language
8.4.13 Reset Resetting the control unit to the factory setting (operating hours are not reset).
8.4.14 Current monitoring Continuous current measurement (monitoring) of the INNO-CLEAN ® system. The pre-
set values should not be changed. Current monitoring is deactivated by setting the bot-
tom current limit to 0.0 A.
Information
Maintenance
Positions
Float
Date/time
Pressure sensor
Classes
Parameter
Nominal size
Parameter storage
Pressure monitor
Communication
Language
Reset
Electricity control
Inno-Clean_2. Generation_3-sprachig_132Seiten:010-341 Stand 05/07 26.11.2009 12:44 Uhr Seite 118