Kessel Aqualift Comfort 230V Mono, Руководство пользователя

Страница: 32 / 108

EN
5.4 Switching off
Disconnect the device from the mains connection,
the acoustic alarm sounds and the alarm LED flashes
Switch off the acoustic alarm: to do so, press alarm but-
ton for approx. 1 second until the alarm symbol is shown
crossed-out in the display.
Keep the alarm button pressed (at least 5 seconds) until
the display and the alarm LED are switched off.
The Aqualift control unit is switched off.
5.5 Overview of configuration menu
Overview menu
The control menu is split into four menu areas:
0 System info -
selected system, configured sensors, cur-
rent measured values; if applicable, events or error mes-
sages
1 Information - display of the operating data (e.g. voltage,
current measured values, logbook or set parameters)
2 Maintenance
- maintenance-relevant tasks (e.g. switch
pump(s) on/off), self-diagnosis, maintenance date and inter-
val)
3 Settings - setting of the switching levels, sensor and sys-
tem configuration, configuration of the modem interface,
resetting the control unit
- or float indicator
1
(1) Number of the menu item
Menu texts Aqualift 230V
0. System info
1. Information
1.1 Hours of operation 1.1.1 Total running time h 0 - 999,999.9
1.1.2 Run time pump 1 h 0 - 999,999.9
1.1.3 Operating cycles 1 X 0 - 999,999.9
1.1.4 Power outage X 0 - 999,999.9
1.1.5 Energy usage X 0.0 - 999,999.9
1.1.6 Run time pump 2 h 0 - 999,999.9
1.1.7 Operating cycles 2 X 0 - 999,999.9
1.2 Log book
1.3 Control type
1.4 Maintenance date 1.4.1 Last maintenance mm:hh - dd.mm.yy
1.4.2 Next maintenance mm:hh - dd.mm.yy
1.5 Current measured values 1.5.1 Mains power V 0 - 99.9
1.5.2 Battery voltage A 0 - 99.9
1.5.3 Level mm 0 - 5000
1.6. Parameter 1.6.1 On delay
1.6.2 Post run time s 0-99
PW: 1000 1.6.3 Total run occur
1.6.4 Max. current A 0.5 - 2.5
1.6.5 Min. current A 0.5 - 2.5
1.6.6 Max. run occur
1.6.7 Max. run time 0
1.6.8 Air compressor offset
1.6.9 Sensor height
1.6.10 SDS self-diagnosis system
32 / 108 010-910_02