1
2
Maintenance
9 Maintenance
9.1 General
Danger!
Personal injury or damage to the machine may occur.
Before using the machine, check all safety-related parts and the hydraulic
connections.
●
Tighten the sweeping roller tension rod after the first 5 operating hours.
●
Grease the spindle of the support wheels as required.
●
Check the drive chain for voltage every 20 hours of operation and light as required
Grease.
●
Grease the grease nipple on the ball race as required.
9.2 Maintenance
●
The sweeper must be subjected to regular maintenance.
●
After carrying out the work, all dismantled safety devices must be removed
be properly installed again.
●
After the first 5 hours of operation, check all bolts and bolts
Bolt connections.
●
Lubricate or lubricate all moving parts.
●
Check the hydraulic connections for leaks before each use.
●
Check hydraulic connections for the first time after 5 operating
Important NOTE:
Only tightening has no success!
Please unscrew a leaking hydraulic fitting first, then hose
or screwing move. Now the screw can be tightened again.
9.3 Daily test
●
Check the safety elements and moving parts before each use
on wear.
●
Check the hydraulic connections and lines.
●
Perform a test run before each use.
●
Clean the device after each use.
●
Sweeping roller: Turn up both support wheels for storage,
until the sweeping roller is unloaded.
●
Side brush: Store only when lifted.
9.4 Maintenance after 20 or 100 operating hours or longer downtime
●
At regular intervals and always at the beginning and end of the season, the
moving parts of the unit must be greased or oiled.
●
Check the tension of the drive chain and grease slightly.
●
Grease the spindle of the wheels.
●
Make sure the gear unit is tight.
9.5 Sweeping roller installation or change
●
First remove the tension rod,
●
Then loosen the three screws of the bearing shell and remove the bearing.
●
Remove the drive tube, insert the sweeping roller into the machine and the drive tube
reassemble with the bearing.