1
0
Service
7 Installation
7.1 Attachment of sweeper
Severe injuries to the operator or third parties may occur. Switch off the tractor and remove the
ignition key before mounting or dismounting the mounted sweeper.
Suspend the sweeper in the front or rear hydraulics or in the front loader of the tractor.
Adjust the horizontal width of the mounting frame according to the tractor type and lock
with two screws on the right and left.
For the front loader attachment, an additional bracket is necessary - this requires two
through holes of 12.5mm Ø on the mounting frame.
Adjust the top link until the roof of the sweeper is horizontal.
Now guide the two hydraulic hoses (supply and return) of the sweeping roller drive
through the rings on the attachment frame to the tractor and insert into the plug-in
coupling so that the sweeping roller rotation direction is correct.
7.2 Installation of dirt collector and splash guard
First, insert the two carrier tubes left and right through the holders on the sweeper. Then secure the
container and the splash guard on both sides by the bolts at "A" and the container additionally by
the bolt at "B" (see sketch on next page).
The bolts are each secured by linch pin.
The splash guard falls by its own weight diagonally against the sweeper base housing and the two
rubber straps at the top and bottom close the space between sweeper and container.
Notes: Tighten all
hydraulic fittings before the test run.