Kersten B00002, Оригинальное руководство по эксплуатации

Страница: 12 / 28

11
Safety instructions
3.5 Instructions for Use for Starter Batteries
1. Removal and installation of the battery
•
Before removing the battery, switch off the engine and all power consumers.
•
Avoid short circuits due to tools.
•
When removing, first disconnect the negative pole (-), then the positive pole (+).
•
Clean battery terminals and pole terminals and treat with acid-free grease.
•
Clean the footprint / support before installing the battery.
•
Tighten the battery firmly.
•
When installing, first connect positive pole (+), then negative pole (-).
•
Make sure that the pole terminals are secure.
•
Leave at least one gas outlet unlocked.
•
This also applies to the return transport of used batteries.
2. External loading
•
Read and follow the operating instructions of the charger manufacturer!
•
Check electrolyte level before charging and level if necessary.
•
Disconnect the battery cable and remove the battery from the vehicle.
•
Ensure good room ventilation.
•
Use only suitable DC chargers.
•
Connect the positive pole (+) of the battery to the plus output of the charger. Connect
negative pole (-) accordingly.
•
Only switch on the charger after the battery has been connected and switch off the charger
after charging.
•
Charging current should be 1/10 Ah of battery capacity.
•
Interrupt the charge if the acid temperature exceeds 55 ˚C.
•
Battery is fully charged if charging voltage does not increase within 2 hours.
3. Maintenance
•
Keep the battery clean and dry.
•
Do not use any improvers.
•
Do not open the battery.
•
If the starting power is insufficient, recharge the battery.
4. Start Help
•
Nur genormte Starthilfekabel verwenden und deren Gebrauchsanweisung beachten.
•
Use only standardized jump leads and observe their instructions for use.
•
Use only batteries of the same nominal voltage.
•
Switch off the engine from the helping vehicle.
•
First connect both positive terminals (+) with the red jumper cable. Then connect a pole
tongs to the negative pole (-) of the dispenser battery. Then clamp the second pole on one
of the bare spots of the needy single-axle tractor.
•
Start the helping vehicle, then max. The engine of the auxiliary towing vehicle max. Start 15
seconds.
•
Disconnect the cable in reverse order.