English
-
5
-
Turning the hot water generator off
To turn the appliance off, place the temperature regulator B in
the “min” position and the main ON/OFF switch A to “0”. Unplug
from the mains electricity supply.
Turn the appliance on and off by means of the main switch only
and never by plugging in or unplugging the mains plug.
Never unplug by pulling the power cable.
Operate the H.P water cleaner for at least 0 seconds to cool
the boiler.
Turn the H.P. water cleaner off, following the instructions in the
accompanying manual.
Important
In common with all other technical appliances, your hot water
generator must always be used according to the instructions.
After use, disconnect the hot water generator from the H.P. water
cleaner and empty the water circuit of residual fluids, disposing
of the contents in accordance with current regulations.
Do not dispose of residual fluids in the environment.
1 When using any electrical appliance, certain fundamental
rules should be respected:
·do not touch the appliance with wet hands or feet;
·do not use the appliance with bare feet or unsuitable cloth
-
ing;
·do not pull the power cable or appliance itself to unplug the
plug from the mains.
The hot water generator should not be used by children,
adolescents or other persons unfit to operate it (for example,
while drunk).
Keep people away from the appliance while it is working.
Do not use the appliance in the rain.
Do not obstruct ventilation and heat dispersal apertures or
slits.
6 In the event of breakdown or malfunction, turn the appliance
off. Do not attempt to repair it. Contact our technical service
centre.
Do not use the hot water generator if the power cable is dam
-
aged. To replace it, contact our technical service centre only.
8 Do not clean the appliance with water jets.
9 Use suitable personal protection (gloves, masks, etc).
10 The appliance must never be left unattended when in func
-
tion.
11 If the appliance is used in a closed room, install a fume
evacuation system and ventilate the room adequately.
GENERAL WARNINGS
Control panel (fig. 5)
A – Main ON/OFF switch 0-I
B – Water temperature regulator.
Turning the hot water generator on:
To turn the hot water generator on, place the main ON/OFF
switch in the “I” position (fig. ).
Rotate the temperature regulator B to the required value ac
-
cording to the type of washing and surface to be treated (fig.
).
Start up the water cleaner, following the instructions in the ac
-
companying manual.
To eliminate impurities or air bubbles from the water circuit, turn
the water cleaner and generator on for the first time without the
lance and allow the water to run for several seconds.
Impurities could block the nozzle and prevent it operating (fig.
6).
Only maintenance authorised in this booklet may be carried out
by the user. All other operations are prohibited.
Before carrying out maintenance of any kind, unplug the hot
water generator from the mains.
The appliance can be disconnected from the mains only by
unplugging the plug from the mains socket.
When maintenance has been completed, before reconnecting
the hot water generator to the mains, check that the panels have
been replaced correctly and fixed using the screws provided.
FROST PROTECTION
The hot water generator most not be allowed to freeze.
After use or when stored for long periods, if there is a risk of
temperatures below freezing point, the hot water generator must
be detached from the water cleaner, the water circuit emptied
and the residual fluids disposed of in accordance with legislation
in force in the country concerned.
MAINTENANCE
USING THE HOT WATER GENERATOR
!
!
!
!
!
Содержание FIRE 30
Страница 3: ...2 Fig 7 Fig 8 Fig 5 Fig 6 Fig 3 Fig 4 A B...
