Kernau KDI 6754, Руководство пользователя

Страница: 60 / 124

60
FAULT POSSIBLE CAUSE TROUBLESHOOTING
Partial food wastes
remain on the dishes
Dishes placed incorrectly,
sprayed water not reaching
affected dishes
Do not overload baskets
Dishes leaning each another
Place dishes as instructed in
the section on loading your
dishwasher
Not enough detergent used
Use the correct amount of
detergent, as instructed in the
programme table
Wrong wash programme
selected
Use the information in the
programme table to select the
most appropriate programme
Spray arms clogged with food
waste
Clean the holes in the spray
arms with thin objects
Filters or water drain pump
clogged or filter misplaced
Check the drain hose and filters
are correctly fitted
Whitish stains remains
on dishes
Not enough detergent used
Use the correct amount of
detergent, as instructed in the
programme table
Rinse aid dosage and/or water
softener setting set too low
Increase rinse aid and/or water
softener level
High water hardness level
Increase water softerner level
and add salt
Salt compartment cap not closed
properly
Check that the salt compartment
cap is closed properly
Dishes do not dry
Drying option is not selected
Select a programme with a
drying option
Rinse aid dosage set too low Increase rinse aid dosage setting
Rust stains form on the
dishes
Stainless-steel quality of the
dishes is insufficient
Use only dishwasher-proof sets
High level of salt in wash water
Adjust the water hardness level
using water hardness table
Salt compartment cap not closed
properly
Check that the salt compartment
cap is closed properly
Too much salt spilled in the
Dishwasher while filling it with
salt
Use funnel while filling salt
to the compartment to avoid
spillage
A poor mains grounding
Consult a qualified electrician
immediately
Detergent remains in the
detergent compartment
Detergent was added when the
detergent compartment was wet
Make sure detergent
compartment is dry before use