6.3 Configuring the two serial interfaces
The 2 output ports of the unit are identical.
Each port has the same functionality and may be connected to a PC or printer.
(configuration of print-out is achieved via the menu of the balance)
To set the parameters for the two interfaces, call the
relevant menu.
One of the following operating modes may be set for each interface.
rE CR, AU PC, AU Pr, Pr PC and bAPr.
For respective definitions please refer to the operating instructions of the balance.
You may also select a baud rate for each interface.
1200, 2400, 4800, 9600, 19200, 38400 baud.
Settings for interfaces:
The menu of
interface 1
and the related steps to be taken are described below:
To set interface 2, use the
Mode2
or
Print2
key.
6.4 Display background illumination
To set the backlighting, use parameter bL
ON – backlighting turned on
OFF – backlighting turned off
CH – automatic cut-off of backlighting after 20 seconds.
Setting the backlighting
Balance display
Press the
Mode 1
key and keep it pressed down. Additionally
press the
Print1
key and keep it pressed down until “
Pr 1
”
appears. Release both keys.
Pr 1
Press the
Print1
key 2 x, "
bL
" appears.
bL
Press the
Mode1
key
bL Ch
The mode can be converted using the
Print1
button
( Ch, on, off ).
bL on
The changed setting is taken over by pressing
the
Mode1
button.
Display returns to display mode.
0.0 g
YKD-BA-e-0710
9