27
Drinking bowls with auxiliary pipe heating (222064 and 222065)
When shipped, the heating cable is fitted so that it can be used for the right connection. If the left connection is
to be used, loosen the screws on the bottom of the drinking bowl, pull out the heating cable cover, remove the
heating cable from the heating cable cover and re-install in the heating cable cover using the reverse image.
Make sure that the heated end of the cable is placed at the top in the intake.
Proceed as follows:
1. Check the heating cable for damage.
2. Route the heating cable along the pipe towards the power supply. As you do so, note the following instructions: - The
heating cable can be routed in a spiral around or straight along the water supply line.
- Heatable length of the water supply line: min. 1 m (spiral routing), max. 2 m (straight routing). The remaining 30 cm
of the heating cable is not heated.
- Route the cable so that it is out of reach of animals.
- Cable ends (at plugs or junction boxes) must be easily accessible for repair and maintenance work
- The heating cable must not overlap.
3. Secure the heating cable to the water supply line with aluminium adhesive tape and insulate. This achieves a better
heating result.
4. Attach insulation.
5. Route the connecting cable outside the insulation.
6. Attach gnaw protection.
7. Connect the heating cable to the power supply.
Device type 222064: 230 V
device type 222065: 24 V (transformer required, see accessories)
8. Earth water piping!
Always feed the cable end through at the top.
Seal the open freed-through
with adhesive tape.
