101719
228-1917 REV 1
3
KEPCO, INC.
131-38 SANFORD AVENUE
FLUSHING, NY. 11355 U.S.A.
TEL (718) 461-7000
FAX (718) 767-1102
www.kepcopower.com
email: [email protected]
3.4 REASSEMBLY
CAUTION: Installing the inner screws first can result in damage to the front panel.
1.
Attach front panel with Distribution board A6A1 to the chassis first using two outer screws at the bottom of the
chassis, then two inner screws.
2.
Connect one 4-pin, one 6-pin connector, and one 5-pin connector attached to twisted pairs to connectors J12,
J15 and J14, respectively on Distribution board A6A1 (see Figure 1). Holding the wires, line up the pins on an
angle, then push until straight and press into place; if necessary a screwdriver can be used to apply enough
pressure to front panel to slightly increase separation between front panel and Distribution board A6A1,
enough for the connectors to be inserted.
3.
Attach the fan connector (J10, Figure 1) by inserting the connector straight into the mating socket.
4.
Connect ribbon cable from Distribution board A6A1 to Digital board connector A1J2.
5.
Connect ribbon cable from A4A3 module to Distribution board A6A1 connector J11.
6.
Attach the cover to the chassis using 14 screws. Figure 2 shows the unit after reassembly.
7.
Attach the two mounting ears to the chassis using three screws for each.
8.
Install the power cord, connect the unit to source power, turn on power supply
