Operation
How the Elements Operate
This KENYON cooktop contains ribbon-type
radiant heating elements. When a power level
is set, the element will turn on and “light up”.
The power setting determines how hot the
burner will get and is electronically regulated
which will cause the burner to switch on and
off as needed to maintain the selected power
level.
The special design of these elements direct
the heat up through the ceramic glass
providing efficient cooking. Temperature
limiters are included in each element to
ensure that the safe operating temperature
of the ceramic glass top is not exceeded.
Indicator Lights
There are a series of lights that provide
indications of burner operation and hot
surfaces. These lights are located adjacent to
the control panels. When the control is ON, a
red light will indicate which burner is on.
For your safety, we have incorporated a “HOT”
indicator light. When lit, this light indicates
that some part of the glass ceramic cooktop is
too warm to touch or place articles upon. Do
not place articles other than cookware on the
cooking surface while this light is glowing.
After turning off the burner, the “HOT” indicator
light will remain illuminated until the cooking
zone is safe to touch.
10
READ SAFETY INSTRUCTIONS BEFORE
OPERATING YOUR APPLIANCE
Kenyon PUPS™
Kenyon PUPS™ (
P
op
U
p
P
otholder
S
ystem)
keep pots safe and secure using a very
innovative, patented design.
Up Position
Press the soft bumper down, then release and
a post “pops” up .6” (15mm) to hold your pot
securely in place.
Only model numbers that end
with PUPS will include
this feature.
Down Position
When you have finished cooking and the
cooking surface has cooled, press the soft
bumper down and it will lock in place.
Removal
Removal is only necessary if PUPS™ need to
be replaced or are damaged. Do not
operate cooktop without PUPS™ installed.
Do not remove during operation and when
cooktop is HOT.
To remove simply unscrew
the post by turning it counter clockwise a
quarter turn.
Reinstalling
Place the post back into the appropriate
location in the glass top and turn it clockwise a
quarter turn. This will lock the post into
position.
