1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
33
CALL CHANNEL
The Call channel can be used to store any frequency and
related data that you will recall often. The Call channel can
be programmed with a simplex or split frequency as well as
related data that can be stored in the memory channels.
No matter what mode the transceiver is in, the Call channel
can always be selected quickly. You may want to dedicate
the Call channel as an emergency channel within your
group. In this case, the Call/VFO scan {page 48} will be
useful.
The default frequency stored in the Call channel is shown
below:
The contents of the Call channel cannot be deleted;
however, you can overwrite old data with new data as
described in the next section.
■
Recalling the Call Channel
1 Select the desired band.
2 Press [CALL] to recall the Call channel.
•
"CALL" appears.
•
To restore the previous mode, press [CALL] again.
•
The Tuning control and microphone [UP]/[DWN] do
not function while the Call channel is selected.
■
Changing Call Channel Contents (Simplex)
1 Select the desired band.
2 Select the desired frequency and related data
(Tone, CTCSS, DTSS, etc.) using VFO mode or
Memory Recall {page 31}.
3 Press
[F], [CALL].
•
The selected frequency and related data are stored in
the Call channel. The transmit frequency from a split
memory channel is not stored.
•
The previous mode is restored.
Note: Lockout status is not copied from a memory channel to the
Call channel.
440 MHz
430 MHz
Version
UHF
VHF
144 MHz
144 MHz
U.S.A/ Canada
Europe/ General
