Kenwood TM-942A, Инструкция по эксплуатации

Страница: 37 / 60

33
3 Press [V/M] to return to the frequency adjustment
mode. If necessary, press the Tuning control to
toggle between the Tuning and MULTI/ CH control.
SATELLITE CHANNEL NAME
You can name each Satellite Memory channel using a
maximum of 8 alpha-numeric characters. First, store the
settings to the Satellite Memory channel {above}.
1 Press [M.IN] while in group A–4, then turn the
MULTI/ CH control to select your desired Satellite
Memory channel.
2 Press [MN.IN].
• An entry cursor appears.
3 Select a character by turning the MULTI/ CH control,
then move the cursor using [
[ [ [ [ [
]/ [
a a a a a
]. Press [M.SR]
to go back to Memory Scroll mode. Press [DEL] to
erase the character at the cursor. You can also use
the optional MC-52DM microphone to enter a name
{TS-2000 page 63}.
4 Press [OK] to store the name to the Satellite Memory
channel. Press [CLR] to quit.
5 The stored Satellite Memory name appears above the
main band frequency display on the RC-2000.
QUICK MEMORY IN SATELLITE MODE
While in the Satellite mode, only 1 Quick Memory
channel is available. It uses Satellite Memory channel 9
to store the settings. To store the settings to the Quick
Memory in Satellite mode, press [Q.IN] (L2). The
settings are stored to Satellite Memory channel 9.
To recall the Quick Memory, press [Q.M] while in group
B–4 or press [V/M] while in group A–2, then turn the
MULTI/ CH control to recall the Satellite Memory
channel 9.
CHECKING THE UPLINK FREQUENCY
When you need to monitor the uplink (TX) frequency,
press [M/S] while in group A–2. Each time you press
[M/S], the uplink (TX) frequency and the downlink (RX)
frequency are swapped.
USING XIT/ RIT IN SATELLITE MODE
You can also use the RIT or XIT function while in the
Satellite mode. Press [RIT] (R2) or [XIT] while in group
A–2 to activate the function. When the RIT or XIT
function is ON, the sub-band frequency display shows
the current RIT or XIT offset frequency instead of the
operating frequency. To clear the RIT or XIT offset
frequency, press and hold [RIT] or [XIT].
Note: You cannot activate both the RIT and XIT functions at the same
time in the Satellite mode.
CHANGING THE FREQUENCY BAND
Press [M/S] while in group A–3 to select the band you
want to change on the main band, then press [UP]/
[DOWN] while in group A–1 to select the band you want
to operate. Press [M/S] again to swap the bands.