Kenwood TM-942A, Инструкция по эксплуатации

Страница: 15 / 60

11
!7
Works as an S-meter in the receive mode. Works as
the meter you selected while transmitting.
!8
“ ” appears when the internal TNC is assigned to the
main transceiver.
!9
The Hz digits of the main transceiver operating
frequency appears.
@0
Appears when the frequency point of Program Scan
Partially Slowed is selected on the main transceiver.
@1
When the sub-receiver is switched ON, it shows the
operating frequency for the sub-receiver. However, if
you are controlling the main transceiver functions,
such as RIT, XIT or SPLIT, it displays the frequency
information for these functions.
@2
Serves as an S-meter for the sub-receiver. It also
displays the relative output power when the sub-band
is selected for transmission.
@3
Appears when the MHz Up/ Down mode is selected.
@4
Appears when the Fine tuning function is selected.
@5
“PKT” appears when the internal TNC is operating in
Packet mode.
@6
“
t
M” or “M
s
” appears while a simplex memory
channel is selected. “
t
M
s
” appears while a split
frequency memory channel is selected.
@7
“
t
B” or “B
s
” appears while VFO B is selected. “B”
appears while Menu B is being accessed.
@8
“
t
A” or “A
s
” appears while VFO A is selected. “A”
appears while Menu A is being accessed.
@9
“DSP” appears when one of the DSP functions is
activated.
#0
“AGC” appears when the AGC function is ON. “R”
(Reverse function), “[R]” (Automatic Simplex Check),
or the Repeater shift direction (“–”, “+”, or “=”)
appears.
Note: “=” appears only for E-types.
#1
“ATT” appears when the attenuator function is ON.
“PRE” appears when the preamplifier function is ON.
“P/A” appears when both functions are ON.
#2
“R
t
EQ” appears when the RX Equalizer function of
the main transceiver is ON. “EQ
s
T” appears when
the TX equalizer function is ON.
#3
“EXT” appears while the HF RX ANT connector is
enabled to receive HF band signals.
#4
“NB” appears when the Noise Blanker function is ON.
#5
“A” appears when Auto mode selection is activated.
#6
The current operating mode for the main transceiver
appears.
#7
“PROC” appears when the Speech Processor
function is ON.
#8
“PTT” appears when the main transceiver is selected
for the transmission band. “Ctrl” appears when the
main transceiver is selected for the Control band.
#9
“VOX” appears when the VOX function is ON.