10
TK-885
1. Accessory Connection Cable
(KCT-19 : Option)
The KCT-19 is an accessory connection cable for connect-
ing external equipment. The connector has 15 pins and the
necessary signal lines are selected for use.
1-1. Installing the KCT-19 in the transceiver
1. Remove the upper and lower half of the transceiver case,
and lift the DC cord bushing (
) from the chassis.
2. Remove the pad as shown in Figure 1 (
).
3. Insert the KCT-19 cable (
) into the chassis (
).
The wire harness band (
) must be inside the chassis.
4. Replace the DC cord bushing (
).
5. Connect the KCT-19 to the TX-RX unit (A/2) as shown in
Figure 2 (
).
6. Connect the KCT-19 to the external accessory by inserting
the crimp terminal (
) into the square plug (
), both of
which are supplied with the KCT-19.
1
2
3
4
5
6
7
8
9
1
2
1
3
13
15
Crimp terminal
(E23-0613-05)
B
E
C
B
D
CN6
CN2
CN4
CN3
D
E
B
C
A
Contact /
Square plug
(E09-1571-05)
3
4
6
7
8
9
5
CN1
Fig. 1 /
Fig. 2 /
INSTALLATION /
1
2
3
5
6
7
4
8
9
Содержание TK-885
