3
INSTALLING THE TRANSCEIVER
Hex-headed screw
Microphone hanger
(TK-980 only)
DC power cable
Mounting
bracket
5 x 16 mm
self-tapping screw
4 x 16 mm self-tapping
screw (TK-980 only)
Spring washer
Flat washer
Antenna
connector
Power input
connector
* The above diagram shows the TK-780/ TK-880 transceiver. The antenna connector of
the TK-980 transceiver is different.
Microphone and microphone
cable (TK-980 only)
1
Mark the position of the holes in the dash by using the mounting bracket as a
template. Drill the holes, then attach the mounting bracket using the supplied
5 x 16 mm screws.
• Be sure to mount the transceiver in a location where the controls are within easy
reach of the user, and where there is sufficient space at the rear of the transceiver
for cable connections.
2
Connect the antenna and the supplied power cable to the transceiver.
3
Slide the transceiver into the mounting bracket and secure it using the
supplied hex-headed screws.
4
Mount the microphone hanger, using the supplied 4 x 16 mm screws, in a
location where it will be within easy reach of the user.
• The microphone and microphone cable should be mounted in a place where they
will not interfere with the safe operation of the vehicle.
TK-980 only:
Connect one plug of the microphone cable to the jack on the base
of the microphone, and the other plug to the microphone jack on the front
panel of the transceiver. Place the microphone on the hanger.
FOR PASSENGER SAFETY, INSTALL THE TRANSCEIVER SECURELY, USING THE SUPPLIED
MOUNTING BRACKET, SO THE TRANSCEIVER WILL NOT BREAK LOOSE IN THE EVENT OF A
COLLISION.
12 V vehicle
battery
