6
SCAN
Scan monitors for signals on the transceiver channels. While scanning, the
transceiver checks for a signal on each channel and only stops if a matching
signal is present.
To start/stop scanning, press the key programmed as
Scan On/Off
.
• “Sc” appears on the display during Scan.
• When a signal is detected, Scan pauses at that channel. The transceiver will remain on
the busy channel until the signal is no longer present, at which time Scan resumes.
Note:
To use Scan, there must be at least 2 channels added to the scanning sequence.
P
RIORITY
S
CAN
If a Priority channel has been programmed, the transceiver will automatically
change to the Priority channel when a call is received on that channel, even if call
is being received on a normal channel.
• “P” appears on the display to indicate the Priority channel (depending on dealer setting).
T
EMPORARY
C
HANNEL
L
OCKOUT
During scan, you can temporarily remove specific channels from the scanning
sequence by pressing the key programmed as
Scan Delete/Add
while Scan is
paused at the undesired channel. To temporarily remove a zone, press and hold
Scan Delete/Add
while Scan is paused at a channel in the undesired zone.
• The channel/zone is no longer scanned. However, when scanning is ended and
restarted, the Scan settings return to normal.
S
CAN
D
ELETE
/A
DD
You can add and remove zones and/or channels to and from your scan list.
1
Select your desired zone and/or channel.
2
Press the key programmed as
Scan Delete/Add
to remove a channel or press
and hold the key for approximately 1 second to remove a zone.
• When a channel is added to scan, “cA” appears on the display. When it is removed,
“cd” appears on the display.
• When a zone is added to scan, “GA” appears on the display. When it is removed,
“Gd” appears on the display.
