TK-272G
9
Notes:
●
To start the Firmware Programmer from KPG-56D, the
Fpro path must be set up by the KPG-56D Setup.
●
This mode cannot be entered if the Firmware Programming
mode is set to Disable in the Programming software (KPG-
56D).
●
When programming the firmware, it is recommend to copy
the data from the floppy disk to your hard disk before you
update the radio firmware.
Directly copying from the floppy disk to the radio may not
work because the access speed is too slow.
6-4. Function
1. If you press the [Side2] switch while "PROGXXX" is
displayed, the checksum is displayed. If you press the
[Side2] switch again (while the checksum is displayed),
"PROGXXX" is redisplayed.
2. A transmission speed can be selected by pressing the [Side1]
switch while "PROGXXX" is displayed.
19200 bps: The LED flashes green and red alternately.
38400 bps: The LED flashes orange.
57600 bps: The LED lights orange.
Note:
Normally, write in the high-speed mode.
7. Clone Mode
Programming data can be transferred from one radio to
another by connecting them via their SP/MIC connectors. The
operation is as follows (the transmit radio is the master and
the receive radio is the slave).
1. Turn the master TK-272G power ON with the [Side1]+[
3
]
keys held down. The TK-272G displays "
CLONE ".
2. Power on the slave TK-272G.
3. Connect the cloning cable to the SP/MIC connectors on
the master and slave.
4. Press the [
°
] key on the master while the master displays
"
CLONE ". The data of the master is sent to the slave.
While the slave is receiving the data, "-PC-" is displayed.
When cloning of data is completed, the master displays
"END", and the slave automatically operates in the User
mode. The slave can then be operated by the same program
as the master.
5. The other slave can be continuously cloned. When the [
°
]
key on the master is pressed while the master displays
"END", and the slave the master displays "
CLONE ".
Carry out the operation in steps 2 to 4.
Note: Use the new cloning cable for TK-272G.
You cannot use the old cloning cable for TK-260/270.
REALIGNMENT
Fig. 2
Cloning cable
φ
3.5
φ
2.5
φ
3.5
φ
2.5
GND
REMOTE/TXD
PTT/RXD
8. Self Programming Mode
Write mode for frequency data and signalling etc. Mainly
used by the person maintaining the user equipment.
8.1 Self programming mode setting
Remove D17 from the TX-RX unit (Figure 3). Hold down
the [Side1]+[
●
] switches and turn the power switch on.
When the self programming mode is entered, [SELF]
appears on the display. The mode changes automatically
to Model Select Mode and "PORTABLE" is displayed in
about one second.
Note :
This mode (self programming mode) cannot be set when it
has been disabled with the FPU.
Note :
Self programming is disabled if "a Trunking Board is installed
in this Radio" is selected in the FPU.
Fig. 3
D17
X57-587X
Compoent Side
Note: You can clone the programmed data between the
transceiver frequency version must be same.
Cloning cable parts No.
E30-3410-05 (TK-272G
→
TK-272G)
